Seltron GWD2, Инструкция по установке, Страница: 10 / 20

10
Instructions for use and settings
When the configuration is complete, the WPS button turns off,
ahd establishing of wireless Wi-Fi connections starts, which is
signaled with an orange flashing warning Wi-Fi light .
When the wireless connection is established with theWi-Fi rou-
ter, the signal Wi-Fi light lights green.
If the connection is not established, the Wi-Fi signal light lights up in orange. Possible causes
are as follows:
1) you entered the wrong password. In this case repeat the procedure (on page 9);
2) signal between the wireless router and GWD is too weak. Try to establish a better signal
reception by moving the router or GWD;
3) On the router you need to enable dynamic allocation of the IP (DHCP). Please consult with
your Internet provider and check the instructions that came with your router.
Condition of the signal lights on theGWD while connecting to Wi-Fi network
METHOD B: CONNECT GWD TO A WI-FI NETWORK WITH WPS BUTTON
If your Wi-Fi router is equipped with a
WPS
button (Wi-Fi Protected Setup), the wireless
Wi-Fi connection can been set up easy, via this button.
After a few seconds, the WPS button is switched off and a
wireless Wi-Fi connection starts establishing, which is indicated
by orange flashing Wi-Fi signal light .
On the GWD press the WPS button , which will start to
flash green. Within two minutes press the WPS button on your
Wi-Fi router as well
Once the wireless Wi-Fi connection to the Wi-Fi router is esta-
blished, the Wi-Fi signal light is lightning green.
The WPS button on the wireless router, can be found under different names and acronyms.
Some examples: QSS, QuickSetup, Push'n'Connect etc. If you don't find the WPS button on
your wireless router, please check the instructions that came with your wireless router.
Connecting procedure