DT-E 1.4: SUN PROTECTION SCREEN – VENETIAN BLINDS Z90
Issue 2 / April 2017 / EN
page 36 / 58
10.
Loosen the screw in elastic bracket of head rail to easily
open the lock in the bracket.
11.
Insert the bundle in head rail bracket and secure the
bracket.
12.
Connect the motor to the power supply.
Attention:
The bundle should end at the same height as
the mounted top part of the guide rail ends.
Picture 8 and 9
13.
Prepare installation of the remaining section of the guide
rail in the mounting profile (pre-drill holes for tapping
screws to fasten guide rail). Then insert the gaskets into
that section. The gaskets will be longer than the guide
rail (longer with length of cut off section of guide rail).
Picture 10
14.
The extending parts of gaskets insert into previously
mounted guide rail section. Then put the remaining
section of guide rail into mounting profile.
Picture 11 and 12
15.
After placing the guide rail in mounting profile secure it
with tapping screws or self-drilling screws, as shown in
Fig. 4.
Picture 13
16.
Install cover panels to auxiliary brackets
17.
Check correct operation of the blind.
Picture 14
