Posizionatore angolare APX 700 - Manuale d'uso - 50
Then the execution starts:
The outputs and relative LEDs are set according to the current program (current programming
cycle) and the current position of the encoder, calculated using the relative zero position and the spin
direction. If the encoder read is bad, the behaviour of APX 700 depends on the error recovering mode
set (see proper paragraph in the chapter
Configuration
).
To stop execution press
FN + OFF
: if the keyboard wasn't locked, APX 700 asks for a confirm:
press
ENTER
(
↵
) to stop execution or
ESC
to abort operation.
If the keyboard was locked, you have to enter access code:
If the code is right APX 700 asks for a confirm, otherwise returns to normal execution.
When the execution is stopped, all the outputs are turned off, and the
Configuration/Programming
menu is displayed.
IMPORTANT:
there is a reserved code always valid as backdoor if you forget your own access
code. This code is
371372
.
••
Outputs protection against short-circuit
APX 700 is equipped with a new and useful function relative to the automatic protection of the
outputs against possible short-circuits.
In fact, when an output short-circuit is checked (e.g. the number 15) the instrument switches in high
impedance mode. So, it divides the outputs from the rest of the circuit (avoiding dangerous damages
to the electronic components), it stop the execution of the current cycle and it visualize on LCD the
group (
1
- 1÷4 cams,
2
- 5÷8 cams,
3
- 9÷12 cams,
4
- 13÷16 cams) relative to the damaged output:
Then, press
ENTER
(
↵
) to restart the current cycle execution (if the short-circuit doesn't persist).
••
Warning
Control on instrument delivery that:
- the merchandise correspond to the delivery note;
- the instrument code correspond to the request;
- doesn't exist damages through the transport fault and/or failures.
LOCK KEYBOARD ?
↵
:YES ESC:NO
RUNNING MODE 0
SPEED: 72 RPM 125°
PRESS
↵
TO STOP
RUNNING MODE 0
CODE: XXXXXX
SHORT CIRCUIT B.4
↵
TO RESTART
