INSTALLATION | Installation of SPMC models
38
|
Doc #OI0003 Part #004122 Rev 04 2010
Installation of SPMC models
1
-
Unpack the SP PRO onto a flat surface.
When removing the SP PRO from its
packaging carefully inspect for any damage
that may have occurred in transit. Damage
must be reported to your supplier immediately.
2
- Remove the cover plate(A) by unscrewing
the two thumbscrews near the bottom of the
SP PRO. Using the T10 torx driver undo the 4
screws securing the expansion card(B) and
gently sliding the card down.
3
- Using the T10 torx driver remove the
terminal cover(A) by undoing the 4 screws.
Use the 6mm allen key to remove the transit
bolt(B) positioned below the DC battery
terminals.
Remove the mounting plate from the rear of
the SP PRO.
4
- Choose a suitable weight bearing and
temperature resistant surface to mount the
SP PRO. Max temperature is a30
degrees C, max weight is 40kg. The display of
the SP PRO should be at eye level.
There should be no obstructions to the clear
passage of air. Use the 6 x M8 holes to mount
the bracket, if the SP PRO is being installed
in a mobile situation use the optional mobile
mounting bracket.
5
- Mount the SP PRO on the mounting plate
by first hooking the top of the inverter over
the projections on the mounting plate and
lowering it into position. Care should be taken
to observe Pinch Point warning. Secure the
bottom of the inverter to the mounting plate with
the transit bolt using the allen key provided.
6
- The gland plate can be removed if
required to give greater access to wiring
terminals using T20 torx driver. NB, internal
screws need only be loosened.
