INSTRUCTION MANUAL CODE 80340 REV A
May 2019
(It can be modified without notice) Page: 10
J
.P. SELECTA s.a.u.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
Tel 34 93 770 08 77 Fax 34 93 770 23 62
e-mail: [email protected] - website: http://www.jpselecta.es
6 Control unit
The refrigerator is command from a “digital control unit” and a “main switch
pilot light” in the top panel of the refrigerator.
The “main switch pilot light” is for turning on the power supply.
The green pilot light comes on to indicate that the unit is connected to the mains
and is going to start working.
The green pilot light comes off to indicate that the unit is disconnected and it is
not working. The “digital control unit” is for the regulation of all parameters to
provide the correct working of the refrigerator. Please check all parameters in
chapter 13 in this manual. Keep the manual always near the equipment.
This manual is part of the equipment and it is very important in case of a service
call.
7 Handling
The refrigerator arrives in PET film and packed in a cardboard box on a wood
pallet.
The refrigerator must be transported and handled with care to avoid posing a
hazard to persons or properties.
Never place a refrigerator with an in-built refrigerated unit on its side or turn it
upside down as this may damage or impair operation of the refrigerated unit.
We cannot hold liable for any damage or defects arising directly or indirectly from
an improper handling of the equipment or non-compliance with the safeguards
illustrated above.
8 Installation procedure
· Place the refrigerator in the coolest and best ventilated part of the room. Do
not install the refrigerator near a heat source or direct sunlight.
· Remove the straps securing the cardboard packing
Remove the cardboard. Covering
Remove the PET protection film
Remove the metal transport belt from the compressor (star screwdriver) and
the door support (without screws). Marked with a yellow label.
· Clean the refrigerator with mild detergent and then dry it with a soft cloth.
. Once located and before starting up, it is recommended that the equipment
will be without starting around 24 hours so that the compressor oil and gas
keep in their position.
9 Connecting to the main power supply
This operation must be carried out by professionally and qualified persons.
The refrigerators are complete supplied with a power supply cable for the con-
nection to the main power supply.
A thermomagnetic circuit breaker (not supplied) must be installed between the
mains power point and the power supply cable of the refrigerator.
9.1 Before proceeding make sure that:
· The mains voltage corresponds to the refrigerator indicated on the characteris-
tics label; to ensure proper operation, it is essential for the power supply voltage
to come within a range of +/- 10% of the unit’s rated voltage.
· The electronic system to which the refrigerator is connected is made in compli-
ance with current standard requirements.
· The electric connections and the installation of the thermomagnetic circuit
breaker have been done by qualified person.
