LOCOMOTOR Rotastand...Compact
LOCO-600 MANUAL
7.9 Note the set position of the shin pad.
7.10 If the shin pad is damaged then it must be replaced.
7.11 Remove the shin pad and fit using the 2 alternative fixing holes.
7.12 Check that the screws can be tightened .
7.13 If any of the screws are damaged, then replace them.
7.14 Re fit the shin pad in its original position and check that the screws tighten.
7.15 If the screws cannot be tightened in any of the 4 holes in the shin pad then the shin pad must be
replaced.
7.16 Note the handle height.
7.17 Release the handle and set it to the next height setting higher or lower.
7.18 Ensure that the handle latch engages the handle and retains it in position and check that the handle
clamp wheel clamps the handle to the mast.
7.19 Repeat for all the 15 other height setting positions.
7.20 Re set to the original height setting and ensure that the handle is securely clamped.
7.21 WARNING
Never rotate the Handle clamp wheel
clockwise unless the handle is in place
7.22 Check that the 2 screws holding the brake pedal are tight.
7.23 Check that the SOLO stabilising bar is free to move in and out.
7.25 Check the condition of the soft floor engaging brake pad, replace if worn or damaged.
7.26 Check that the fixing is tight.
7.27 With the SOLO stabilising bar fully retracted check that the brake operates satisfactorily.
7.28 With the SOLO stabilising bar fully extended check that the brake operates satisfactorily.
7.29 Check the condition of the non slip foot pads, replace if damaged.
Select Healthcare (UK) Ltd,
Unit 2 Albert Road, Rushden, Northants, NN10 0BU
Tel: +44( 0)1933 411729 Fax: +44(0)1933 410213 Email [email protected]
Designed and Developed by: Proto Magic Innovations Ltd
Rotastand Compact OPERATING AND SERVICE INSTRUCTIONS Ver 02 .doc 10/01/2013
Page 7
Alternative
fixing hole