20
Fasten the line guide fitting to the line guard
casing using the screws enclosed.
Start by first fitting the line drum half with the
line onto the lower bearing assembly. Tighten the
screws securely. This locks the furling line.
Check that the end of the line is visible through the
inspection hole. Rotate the lower bearing assembly
by half a revolution, and fit the other line drum half.
4.3 Fitting the line drum and line guide – 400 TD
The line drum consists of two halves. It is easier to fit after the Furlex stay is fitted to the mast.
Feed the furling line through the hole in the
line guide fitting and then through the hole in
one of the line drum halves.
Bend the end of the line down so that it
covers the inspection hole
in the line
drum half.
Fig. 4.3.a
Fig. 4.3.b
Fig. 4.3.c
Fig. 4.3.d
Slide the line guard on from aft and turn it half
a revolution as per fig 4.3.d. Press the locking
block in from underneath (arrow 2) so that it
"clips" firmly into place.
Fig. 4.3.e
4.2
4.1
1
1.
2.
3.
1
