Thank you very much for purchasing our LED lighting fittings.
Please read this instruction manual to use the product properly.
1) Prior to installing the fitting, check if the product is as per your order.
2) Check for a loose or damaged part due to an accident in transit, etc.
1)
<1>
<2>
<6>
<1,1H>
<1>
<4>
<1>
<2>
<6>
<1,1H>
<1>
<4>
2) Usable in hazardous areas where there may be deflagrative or flammable dust.
- Installation work should be done properly by a qualified electrician in accordance with the related laws and the instruction manual.
- For safety, Installation work should be done by at least two workers.
■
Direct Mount Type, Pipe Pendant Type, Bracket Type (Fig. 1: Example LKAB070341)
NB: For the bracket type, fix it on a vertical mounting surface securely.
Screw the pipe into the lamp house.
Screw the terminal box cover into the pipe.
NB1:
NB2: Caulk the threaded connections.
NB3:
LKAB
After installing the product, be sure to hand this manual over to the user of the product.
Performance
11E0200002A11
To be conserved
Instruction Manual
Prior to use
Dust Ignition proof type LED Lighting Fittings
LKAB07034
LKAB07035
LKAB07031
LKAB07032
IP
rating
IP65
Type of
protection
SDP-13
LKAB07024
LKAB07025
LKAB07021
LKAB07022
Installation Type
Model
Direct mount
Pipe pendant
Bracket
Stanchion
Pipe pendant
Bracket
Input Voltage
(Frequency)
Input
Current
Power
Consumption
100-242V AC
(50/60Hz)
0.26-0.12A
0.19-0.08A
25.5-26W
18-18.5W
Stanchion
Special direct mount
Horizontal pole mount
Lamp house replacemen
The electrical characteristic data is given below (the figure in angle brackets < > in the Installation Type column is a sign placed at the end of
each model code to represent the type of installation.)
Names of the Components and Installation Method
Special direct mount
Horizontal pole mount
Lamp house replacemen
Direct mount
Fix the terminal box on a horizontal mounting surface securely with M6
bolts or equivalent bolts.
Lift the lamp house and hook the suspension hook onto the suspension
hook hole of the terminal box.
After connection of the electric wires (white and black: power wires,
green: grounding wire), remove the suspension hook and put it in the
terminal box cover.
Fasten the terminal box and its cover with four cross recessed hexagon
bolts.
After adjusting the positions of the lamp house and terminal box,
tighten the three locking screws.
The pipe, locking screws and cross recessed hexagon blots should be
tightened securely. Otherwise, the lamp house might fall.
For the direct mount and Pipe pendant type, The lamp house may
be installed within an angle range of 0° (down).
For the bracket type, the lamp house may be installed within an
angle range of 0° (down) to 45° (oblique). For the direct mount and
Pipe pendant type, The lamp house may be installed within an angle
range of 0° (down).
Terminal box
Suspension hook
Pipe
3-Locking screws
Lamp house
4-
φ holes for M6 olts
Suspension hook hole
Cover gasket
Terminal box cover
4-Cross recessed
hexagon bolts
Fig. 1
- -
