Seitron DCPA80BC, Инструкции по применению

Страница: 16 / 66

18
Installation
- Wall mount.
The adapting plate (Fig. 1), can be fixed using the screws and relevant shells included
in the box or, alternatively, directly on the wall or on 3 modules junction boxes; on the
plate will then be hooked the chronostat body, by placing it from the plastic back side
and sliding it down.
In any case, in order to grant the electrical safety, it is mandatory to screw the chronostat
body to the wall through the two screws supplied which must be mounted in the battery
holder.
The chronostat must be located about 1,5 m. above the floor level, far from heat sources,
doors and windows.
Electrical wirings
The chronostat does not need electric wirings, because it was developed to be a wireless
chronostat.
However some terminals are available (10) Fig. 10 to connect in addition an external
remote sensor input and a telephone interface.
- 4 and 5: telephone interface (optional) for remote driving of the chronostat.
- 6 and 7: remote sensor (optional).
Clock adjustment
In order to set the clock of chronostat (Fig. 7), follow these steps:
1. Open the plastic door covering batteries.
2. Press the button ‘

’ for at least 2 seconds.
3. Set the day with buttons ‘
▲
’ or ‘
▼
’.
4. Confirm with button ‘ OK ’.
5. Adjust current hour with buttons ‘
▲
’ or ‘
▼
’.
6. Confirm with button ‘ OK ’.
7. Adjust current minutes with buttons ‘
▲
’ or ‘
▼
’.
8. Confirm with button ‘ OK ’.
After 1 minute of inactivity on buttons, the chronostat will automatically exit the clock
adjustment mode.
TELEPHONE
INTERFACE
REMOTE
SENSOR