Seitron DCPA80BC, Инструкции по применению

Страница: 22 / 66

24
WARNING
1 To determine the right position ensure that the radio signals transmitted are
correctly received by the receiving unit.
2 To adjust properly room temperature, install the thermostat far from heat
sources, airstreams or particularly cold walls (thermal bridges).
When the remote sensor is used in conjunction with the thermostat, then
this note is to be applied to the remote sensor itself.
3 For remote version all wirings must be made using wires with 1,5 mm
2
minimum section and no longer than 3 m. Do not use same duct for signal
wires and mains.
4 Installation and electrical wirings of this appliance must be made by
qualified technicians and in compliance with the current standards.
5 Before wiring the appliance be sure to turn the mains power off.
In the view of a constant development of their products, the manufacturer reserves the right
for changing technical data and features without prior notice. The consumer is guaranteed
against any lack of conformity according to the European Directive 1999/44/EC as well as to the
manufacturer’s document about the warranty policy. The full text of warranty is available
on request from the seller.