Seip TS Akku II, Инструкция по установке

Страница: 10 / 24

1.
2.
10
Mounting the Shelf
The shelf can take two batteries and is equipped with a 5m cable
to supply the operator with power. Take care to install the shelf
within the range of the 5m cable.
Mount the shelf to the wall using the supplied screws, then run
the cable up to the operators.
Should the distance between the shelf and the operator be less
than 5m, then the excess cable may be winded up -
the polarized plug must not be removed from the cable!
The cable must be run into the operator using the hole in the
base plate. The cable can be kept in place using the supplied black
detensioner.
The power supply cable must be connected to the operators elec-
tronics and a battery must be connected to the shelfs‘ plug before
the operator can be used (refer to page 1).
The Solar Components
Unplug the flat battery
and plug in the fully
recharged battery.
5m cable
for the operators
power supply
Using and Recharging the batteries
Hint: from factory-side the batteries are shipped fully charged
Usage
The shelf will take two batteries. The batteries may be used one
after the other - whilst one supplies the operator with power, the
other may be recharged by means of the supplied charger. After
the battery was fully recharged, it remains beside the active batte-
ry, in order to overtake the operators supply once the first battery
is running low.
The batteries are equipped with handles, allowing easy transport.
Battery Status
The battery status can be seen from the green LED, which can
be found on the operators housing (please refer to page 1). The
green LED will blink in turns of 10 seconds:
- three times or twice: the battery is full
- once: the battery is likely to run flat and should be recharged
soon.
Shortly before the battery runs flat, the operators lighting
will start blinking whilst the operator is running. Once this
happens, the batteries power will only last for one or two mor
openings (dependant on the doors weight).
Here at latest the fully recharged battery must be plugged into
the shelfs plug, whilst the old battery is taken into the house for
recharging it.
Remove the flat bat-
tery to recharge it.