Seiko 8B92, Инструкция по эксплуатации

Страница: 28 / 30

■ Set the stopwatch hands to “0”
Press
Button C for
2 seconds
Press
Button D
3
Press Button C until the stopwatch second
hand starts moving (for 2 seconds).
The stopwatch seconds hand will move and the watch will
switch to “stopwatch seconds hand” preliminary position
alignment mode.
4
Press Button D to set the stopwatch second
hand to the 0-second position.
Continuous
adjustment
When Button D is kept pressed for two
seconds or longer, the hand will start to
move. Press Button D again to stop.
Fine adjustment When the button is pressed intermittently,
the hand will slightly advance.
EN
104
8
TROUBLESHOOTING
Press
Button C for
2 seconds
Press
Button D
0-second
position
5
Press Button C until the stopwatch minute hand
starts moving (for 2 seconds).
The stopwatch minute hand will move and the watch will enter
“stopwatch minute hand” preliminary position alignment
mode.
6
Press Button D to set the stopwatch minute
hand to the 0-minute position.
Continuous
adjustment
When Button D is kept pressed for two
seconds or longer, the hand will start to
move. Press Button D again to stop.
One minute
Advance
Each pressing Button D slightly advances
the hand.
EN
105
8
TROUBLESHOOTING
0 1 2
Push the
crown
back in
After the built-in IC is reset, the time zone is automatically set to LON (London).
* If the watch does not start to move from “0:0:0 AM,” the resetting of the built-in IC may not activate.
In such a case, re-attempt the operation from the procedure “1.”
* When the crown is a screw lock type, lock it. → P.15
7
When all the hands return to the 0-second
position, push the crown back in.
When the crown is pushed back in, the watch starts to work
from 00:00:00.
EN
106
8
TROUBLESHOOTING
■ Set the date to “1” (1st)
Button A
Press for
3 seconds
Button B
Press for
3 seconds
30-second
position
8
Press and hold Button A and Button B
simultaneously until the small seconds
hand stops at the 30-second position (for
3 seconds).
The watch switches to the preliminary position
alignment mode for the date.
* When no operation is conducted for 20 seconds or
longer after the watch enters the mode to adjust the
preliminary position of the date, the watch automatically
displays the time again.
If this happens in the middle of the operation, re-attempt
the operation from procedure 8.
* Do not pull the crown out.
EN
107
8
TROUBLESHOOTING