Mounting
Bracket
Sliding
Bar
Sliding Bar
Bottom Cap
9
Cutting the Screen
Housing Assembly
It is easy to cut right through the Screen Housing Assembly of the
Vista Plus Screen using a chop saw or hacksaw.
NOTE:
All cutting will be done on the upper end
of the Screen Housing Assembly. The Mounting
Bracket on the Screen Housing Assembly is
clearly labeled with CUT and NO CUT zones.
1.
Remove the Mesh Lock Adjuster and Sliding
Bar Top Cap from the Screen Housing
Assembly by removing their screws with a
Phillips screwdriver.
(A)
2.
Detach the Sliding Bar from the Sliding Bar
Bottom Cap, and slide it towards the upper
end of the Screen Housing Assembly
until it is aligned with top of the Assembly
and the mesh.
(B)
3.
Slide the Mounting Bracket until its upper
edge is aligned with the upper edge of the
Screen Housing Assembly.
(C)
4.
With all components aligned, carefully
measure and mark the Screen Housing,
Sliding Bar and Mounting Bracket on all sides
based on the “Length to be cut”
dimension calculated on Page 7.
(D)
5.
Wearing safety glasses, cut straight
through all components of the
assembly. Use a file to remove any
burrs from the cut surfaces.
6.
Re-attach the Sliding Bar onto the
Sliding Bar Bottom Cap.
(B)
Make sure
that it is pushed in as far as it will go.
7.
Re-attach the Mesh Lock Adjuster and
Sliding Bar Top Cap to the Screen Housing Assembly and replace the screws.
(A)
8.
Slide the Mounting Bracket completely off the Screen Housing and set aside.
Mounting
Bracket
Mesh Lock
Adjuster
Sliding Bar
Top Cap
Length
to be cut
D
C
B
A
