12
Installing the
Bottom Rail
and adjusting the Catch
If the Bottom Rail did not require cutting, it is important to
select the correct Bottom Rail for installation. The Vista Plus
Screen package comes with two Bottom Rails to
accommodate both flat and angled door sills.
Please refer to
(A)
to determine the correct Bottom Rail.
1.
Remove the backing on the adhesive strip on
the Bottom Rail.
2.
While slightly lifting the Sliding Bar,
insert one end of the Bottom Rail
into the groove at the bottom of
the Sliding Bar Bottom Cap.
(B)
NOTE:
If using the Angled Bottom Rail, ensure
that it is oriented so that the top of the Bottom Rail
is flat and level when placed on the door sill.
3.
Position the other end so that the center of the Catch Frame aligns with the center of the
Bottom Rail.
(C)
When aligned, press the Bottom Rail firmly onto the door sill.
4.
Fasten the Bottom Rail to the door sill using the
5/8” (16 mm) Self-Tapping Screws provided.
It is not necessary to pre-drill the surface
below.
Adjusting the Catch
1.
Loosen the screw on the Catch.
2.
Move the Catch up and down, until the position
where the Latch makes a secure contact with
the Catch is determined. Tighten the screw on
the Catch to secure it in place.
(D)
3.
Adhere the Stickers to the front and rear of the
Latch as indicated.
(E)
Bottom Rail T
y
pe “B”
An
g
le
d
Surfa
c
e
Bottom Rail T
y
pe “A”
Flat Surfa
c
e
Bottom
Rail
Bottom
Rail
Sli
d
in
g
Bar
S
c
reen Housin
g
Bottom Rail
Ali
g
n The
Centre
Cat
c
h
Frame
5/8” (1
6
mm)
Self Tappin
g
S
c
rew
Sli
d
in
g
Bar
Lat
c
h
Cat
c
h
Frame
Cat
c
h
Sti
c
ker
Lat
c
h
Sti
c
ker
B
A
C
D
E
