Sega SEGA RALLY CHAMPIONSHIP TWIN TYPE, Руководство пользователя

Страница: 60 / 106

57
To assemble your Rally 2 Twin Game locate the Left Cabinet (side with on/off switch), Cash Box Tower, and Right
Side Cabinet. In the parts bag located in the cash box, locate the Opto Cable. this will be needed later, to connect
together the opto connections on the rear of the Cash Box Tower. The hardware needed to assemble your Rally 2
Twin game has been threaded into the proper holes. This was done to insure the bolts thread properly into the T
nuts in the Cabinet.
At this time remove the rear cover of the Cash Box Tower.
Notice the wire harness taped to both sides of the cabinets and Cash Box Tower. On the wireharness connections
Black is for the left side, yellow is for the right side viewed from the front. Locate left side cabinet (on/off switch)
and Cash Box Tower. Connect the 15, 4 and 2 position connectors together. At this time connect the Opto cable
(without white lable) to the Opto connection nearest to the left side of cabinet (viewed from the front). These Opto
connections are in the rear of the Cash Box Tower.
You may elect no to connect the connector at this time, but carefully push connectors in the hole so they are still
accessible from the outside of the cabinet.
There are 4 bolts in the NON SLOTTED HOLES, on the side of the cabinet, the 2 on top under the the ledge must
be removed. The 2 on the bottom must be loosened about 1/4 inch. Lift up the Cash Box Tower and using the 2
lower slotted holes on the bottom of the Cash Box slip them over the lower protruding bolts and slide the cash box
into place. Open the Coin Door and install the 2 upper bolts through the cash box into the cabinet. tighten all 4
bolts.
The Right side of the cabinet gets installed the same way as the left side.
1
2
3
4
5
6