Sega Let's Go Jungle, Руководство пользователя

Страница: 86 / 167

CONTROL UNIT
81
11
7
Remove the hexagon nuts attaching the volume
bracket lower to the volume and remove it from
the bracket. The bracket will be used with the
replacement part.
FIG. 11-2f
8
The wire attached to the volume will be used with the replacement part. Remove the old heat shrink tubing
attached to the wire using the nippers or cutters.
9
Use the soldering iron to melt the solder and re-
move the wire from the old volume. You must take
the utmost care when using the soldering iron.
FIG. 11-2g
10
If the lead wire on the end of the wire terminal is less than five millimeters, use wire strippers or cutters to
peal back the covering.
11
Pass the wire through each of the heat shrink tubes.
12
Solder the wire terminal to the replacement volume.
Use the wiring diagram to make sure you don’t solder in the wrong place.
13
Use the industrial dryer to apply heat and attach the heat shrink tubing to the soldered area.
14
Attach the gears and bracket to the volume.
15
As in the above adjustment method, with the Control Unit’s left and right axis perpendicular to the screen,
engage the gears with the D cut face of the volume axis in the direction shown in the diagram and attach it
to the Control Unit. (See FIG. 11-2b).
Note that the directions are different for 1P side and 2P side.
SOLDERING IRON
HEAT SHRINK TUBE