31
Dismantling the Hopper
1. Gently pull outwards the securing clips on the back of the base.
2. Tilt the bowl forward until it is clear of the clips.
3. Slide the bowl forward until the locating lugs, at the front of the bowl, are clear of the slots in the
base.
4. Lift the motor assembly out of the base.
5. Disconnect the cable from the motor assembly.
Hopper Assembly
1. Connect the cable to the motor assembly, ensuring that the 4-pin connector is the correct way
round.
2. Lower the motor assembly into the base, ensuring that the coin exit is in the rear exit position.
(Towards Coin exit position).
3. Locate the lugs, on the front of the bowl, into the slots at the front of the base.
4. Gently press down until the securing clips, on the base, click into the slots in the bowl.
Routine cleaning:
All accessible parts of the coin route should be cleaned periodically using a mild detergent on a damp
cloth. No spray solvents should be used. Particular attention should be paid to the opto sensor at the coin
exit to remove any build up of dirt.
Содержание Club Kart Prize
