Sega AV F-ZERO AX, Руководство пользователя

Страница: 160 / 252

− 153 −
CIRCUIT PROTECTOR
If a problem occurs, first check to make sure that the wiring connectors are properly connected.
18 −５ PROBLEMS NOT COVERED BY ERROR MESSAGES
● In order to prevent electric shock and short circuit, be sure to turn
power off before performing work.
● Be careful so as not to damage wirings. Damaged wiring can cause
electric shock or short circuit.
● After removing the cause of the functioning of the Circuit Protector,
reinstate the Circuit Protector. Depending on the cause of the
functioning, using the Circuit Protector as is without removing the
cause can cause generation of heat and fire hazard.
● In the event that a problem cannot be resolved by employing the
procedures listed in this Manual, be sure to request service from the
office shown on this Manual or the dealer from whom the product was
originally purchased. Attempts to employ procedures other than those
specified in this Manual can cause electrical shock, shorting, or fire.
● In the event of a problem that is not described here, be sure to contact
the office shown on this Manual or the dealer from whom the product
was originally purchased. Careless attempts at repair can result in
electrical shock, shorting, or fire.
Functions due to the activation of
bimetal. To restore the function, wait
for approximately one minute or
longer until the bimetal cools off.
(Press the Button.)
FIG. 18. 5
CIRCUIT PROTECTOR
TABLE 18. 5
When the main SW is
turned ON, the machine
is not activated.
Fluorescent lamp inside
light box doesn't light
up.
The power is not ON.
Incorrect power source/voltage.
The CIRCUIT PROTECTOR
functioned due to momentary
overcurrent.
The fuse of the fase holder was blown
out due to momentary overcurrent.
Connector connection fault.
Fluorescent lamp and Glow lamp need
replacement.
Firmly insert the plug into the outlet.
Make sure that the power supply/voltage are
correct.
After eliminating the cause of overload, have
the Circuit Protector of the AC Unit restored.
(See Section 6 4 , Refer to the following.)
After eliminating the cause of overload, replace
the specified rating fuse. (Fig. 18. 5 c)
Check connector connections between the
Cabinet and the light box.
Replace the fluorescent lamp and the glow
lamp. (See Section16.)
PROBLEM CAUSE COUNTERMEASURES