Sega AV F-ZERO AX, Руководство пользователя

Страница: 134 / 252

− 127 −
D CUT SIDE
Horizontal and
facing downward
⑥ The wires connected to the old VR can be reused for the new VR. Remove the heat contraction
tube covering the soldered areas, use the soldering iron to melt the solder, and remove the wires
from the VR.
⑦ Solder the wires to the new VR. Check the wiring diagram to make sure there are no mistakes in
the wiring. In addition, use a heat contraction tube or other device to prevent short-circuiting.
⑧ Install the new VR and the gear in the Roll VR bracket.
⑤ Remove the nut
securing the roll VR
bracket and then
remove the VR from
the bracket.
⑩ Check to make sure the seat is level.
⑪ Install the Roll VR unit. Insert the Roll VR unit without causing the gear to rotate and secure it
with 2 screws.
The gear engagement should also be adjusted at this time.
⑫ Check to make sure the "SEAT MOTION" value on the Input Test screen is within the range
80H ± 8H when the seat is level. If the value is outside this range, adjust the VR again.
NUT
SPRING WASHER
FLAT WASHER
ROLL VR BRACKET
VR
220-5484、220-5753
PHOTO 12. 2 e
⑨ Rotate the gear so that the D-cut side of the VR axle is
horizontal and facing downward.
PHOTO 12. 2 f
D CUT SIDE
Horizontal and
facing downward
④ Loosen the 2 hexagon socket screws
holding the gear in place and remove the
gear from the VR axle.
PHOTO 12. 2 d
GEAR
FIG. 12. 2
HEXAGON SOCKET SCREW (2)
Ｍ3×6