Step 6 — Installing the PSU Blocker Overview
This animation will provide you with
an overview of what will be
assembled.
Step 7 — Installing the PSU Blocker
Install the PSU Blocker sides using (2) M4 x 12 screws and washers per side (In base electronics
hardware pack - 84493).
If you are located in the US, make sure the 220/110 switch is in the 110 (115) position, as
indicated by the arrow. This defines the input voltage the power supply expects.
If you're in a country where 220v is the standard, make sure the switch is on the 220 setting.
Step 2. REV2 Rostock Max v3 Base Assembly
Draft: 2018-07-27
Guide ID: 66 -
This document was generated on 2019-10-01 12:14:14 AM (MST).
© 2019
seemecnc.dozuki.com/
Page 7 of 12
