SENSOR
T
OUCH
RemoteControl
SEELEY INTERNATIONAL –
INSTALLATION & OPERATION MANUAL
4
SETTING THE CLOCK
TURNING
THE COOLER
Set the clock on the remote control before proceeding
with any other programming.
The clock can only be set with the remote control
switched OFF. Hold the
button down for over 2
seconds, until the hour flashes.
Use the
and
buttons to change the hour.
To change minutes, press the
button again.
Change the minutes using the
and
buttons.
To lock in the time setting, and enter the OFF state, press
the
button. The display will stop flashing.
The remote control is switched on and off using the
button. The memory will store
The clock can be set to
either 12 or 24 hours (see page 6). If the clock is set to 12
hours make sure that the AM/PM displayed on the screen
is correct. AM/PM will change with adjustment of the hour.
and use the settings from
when the cooler was last used. Once the remote control is
on, you can choose between MANUAL, AUTO and AUTO
TIMER modes by pressing the
button.
With the remote control ON, press the
button until
MANUAL is shown in the top left corner of the display.
The
button is used to select VENT (where fresh air
is being delivered without being cooled) or COOL.
ON
MANUAL MODE
Once either COOL or VENT has been selected, the
remote control will maintain a constant fan speed.
This is indicated by the bar graph in the centre of the
display.
To decrease or increase the fan speed required,
press either the
or
buttons.
ILL1104-A
PM
AUTO MODE
The remote control contains a thermostat. In AUTO
mode the cooler is controlled automatically, based
on your pre-selected comfort level. The cooler will
adjust the fan speed, switch between COOL and
VENT and turn itself off. However, the sequence
and regularity at which these settings change will
differ with each operation of the cooler.
As the remote control senses room conditions, the
comfort control settings will be influenced by heat
from direct sunlight or electrical appliances.
Likewise placing the remote control in cupboards
or drawers or under cooling vents will affect the
cooler
’
s operation.
To set the AUTO mode press the
button until
AUTO is displayed.
Ten levels of comfort are available with the remote
control. While in AUTO mode pressing the
and
buttons will adjust the level of required
comfort. The display will show your selection by
indicating a level between 1 and 10. WARMER or
COOLER will be displayed on the screen as
settings are changed.
AUTO TIMER mode can be selected by using the
button. Once the AUTO TIMER mode is
selected the cooler will only operate during the
programmed time period.
AUTO TIMER MODE
MANUAL
VENT
FAN
SPEED
ILL1109-A
AUTO
FAN
SPEED
ILL1105-A
PM
1
Using the
Remote Control
SENSOR
TOUCH
