Powerstick
5 Operation
10
5
Operation
5.1
Starting up
The last settings are restored when the device is switched on. This also applies to the choice of the
preset bank. When the start-up is completed, the system is in status mode. If the red Mute LED
lights up depending on the previous setting, no signal is being transmitted. Pressing the set button
once deactivates the mute function, the mute LED will go off and the system is ready for operation.
5.2
Selecting a bank
The loudspeaker presets are stored in the DSP controller in up to 3
banks. To change banks, press and hold the Mode button whilst the
loudspeaker is switched on.
1. Press and hold the Mode button.
2. Connect the power cable (PowerCon blue).
3. Corresponding LEDs blink to indicate the chosen bank.
4. Release the Mode button.
When the power cable is connected, the level and/or preset LED
lamps blink to indicate which bank is selected. The level LED blinks
to indicate the first bank, the preset LED for the second. The third
bank is indicated by both LEDs blinking.
If only one bank is programmed, there is no possibility to switch the
bank.
Bank 1
– L-Series
Bank 2
–
Default Settings
Bank 3
– i-Series
2x L16 Fullrange
2x HP 50Hz
2x i4 Flat
2x L16 HP 180Hz
2x Low-Boost
2x i5 Flat
L16 HP + G Sub 1201 160Hz
Top + Sub 160Hz
i4 HP + G Sub 1001 160Hz
L16 HP + G Sub 1501 140Hz
Top + Sub 120Hz
i5 HP + G Sub 1001 120Hz
