• Installation
• Jumper Setup as master or Slave, Following the
`
Direction of Surface of Hard Disk.
• Jumper Located at Hard Disk Data Cable or
1
Rear Side of Hard Disk.
• If One Hard Disk Installation, Setup as Master
If Two Hard Disk Installation, Second One Setup as Slave.
① Jumper Setup as Master or Slave
18
1. Hard Disk Installation
※ Example of Samsung HDD Jumper Setup
• Refer to General Pin Setting in Jumper Pin Setting on HDD Surface.
• When One HDD Install, Setup Pin as Master and Connect Pin
1
at the Left End of Jumper.
• When Two HDD Install or Additional Install, First One Setup as
1
Master and the Other is for Slave. Slave Setup has No Pin.
• When More than Two HDD install, Setup as Master or Slave
1
to Connect One IDE Cable at the Same Method of Above.
!!Please Use Hard Disk which Possible to Supply Higher than
UDMA66
.!!
‼ When Hard Disk Add or Exchange,
Must System Off
Properly (System Off by Power Button)
. If not, it
’
s a
Cause of Fatal Hard Disk Error.‼
② IDE Cable Connection to Main Board
• Confirm the IDE Cable Inside of Product
• Among the Three Connector, Indicated Blue Color
1
Connector Must be Connected with Main Board. Other
1
Connectors Connected with HDD