Secutron MR-2320 Series, Инструкция по установке и эксплуатации

Страница: 47 / 92

47
Configuration
Command Menu-->Panel Config-->
Hazard Config
1. Release Timer
60->Default
Available options:
0,5,10,15,20,25,30,35,40,
45,50,55,60 seconds
Use this function to set the
programmable timer that delays
the activation of the releasing
application circuits.
This timer starts immediately
after receiving a confirming
alarm (cross-zoned hazard
area) or a single alarm (non-
cross-zoned hazard area).
When the timer expires, the
releasing circuit activates.
Value: 0 to 60 seconds in five-
second increments.
Command Menu-->Panel Config-->
Hazard Config
2. Abort Delay
[X] Standard UL->Default
[ ] IRI
[ ] NYC
[ ] Local Juris.
Use this function to set how the
Abort Switch operates with the
Release Timer.
Note that if the Release Timer is
set to zero, the Abort Switch
does not operate.
In standard UL mode, after the
Abort switch is pressed, the
release timer will reset and then
restart. If the switch is held for
any time up to 50 seconds, then
the releasing device will actuate
60 seconds after the switch is
pressed. However, if the switch
is held for longer than 50
seconds, then the releasing
device will actuate 10 seconds
after the switch is released.
In
IRI mode, the switch works in
the same way as it does in
Standard UL mode, except that
the switch will function only if it
is pressed and held before the
second alarm comes in.
In
NYC mode, pressing the
Abort Switch will reset to the
Release Timer and add 90
seconds to the configured timer
duration. After the Abort Switch
is released, the Release Timer
will restart.
In
Local Juris. (Local
Jurisdiction Delay), pressing the
Abort Switch will reset the
Release Timer back to its
configured value. After the
switch is released, the Release
Timer will restart.
Command Menu-->Panel Config-->
Hazard Config
3. Man. Rls Delay
0->Default
Available options:
0, 5, 10, 15, 20, 25, 30
seconds
Use this function to set the time
delay of activation of
corresponding releasing
circuit(s) after activation of the
manual release switch.
Value: 0 to 30 seconds in five-
second increments.
Command Menu-->Panel Config-->
Hazard Config
4. Soak timer
0->Default (continuous)
The selectable values are
in seconds: 0, 10, 20, 30,
40, 50, 60, 120(2min),
180(3min), 240(4min),
300(5min), 360(6min),
420(7min), 480(8min),
540(9min), 600(10min),
660(11min), 720(12min),
780(13min), 840(14min),
900(15min)
Use this function to set the
length of time for which the
releasing circuit is active. When
the soak timer expires, the
control panel automatically
shuts off the activated releasing
circuit.
0 seconds means that the soak
timer is disabled and the
releasing circuit is active
continuously.
Release timer(sec):
60
Abort Delay Type:
[X] Standard UL
Man. Rls Delay(sec):
0
Soak timer(sec):
0