WIRING:
1. Carefully route the wiring harness of the camera into the vehicle either using a pre-existing
factory grommet or by drilling a hole. If drilling a hole, be careful not to damage anything behind
the mounting surface.
2. Choose a convenient place to run the camera cable up the left or right side of the vehicle. As a
rule of thumb, try to avoid main factory harness looms that may contain high levels or RF noise or
interference.
3. On the brake light harness (The loomed wire harness with the white plastic connector) Connect
the Red wire to the 12 volt brake light wire and connect the Black wire to chassis ground. This will
make the lights for the SV-6900.BL illuminate when the brake pedal is pressed.
4. On the camera harness, Connect the Red wire to the 12 volt reverse light wire and connect the
Black wire to chassis ground.
5. Run the Yellow RCA video cable to the monitor’s video input or reverse camera input.
6. The White RCA does not need to be connected
MONITOR
Connect to +12V
Reverse Light
YELLOW RCA
Connect to Monitor
RED
WIRE
BLACK WIRE
Connect to +12V
Brake Light
Ground
RED
WIRE
BLACK WIRE
Ground
WHITE RCA
No Connection
POWER CONNECTOR