INSTALLATION
MOUNTING:
1. Find a suitable location on the trunk lip or license plate bezel to secure the camera down to
the body of the vehicle
2. Make sure the mounting location that you choose is on a flat surface so that when the camera
is installed there will be no uneven gaps around the edges. .
3. Route the wire harness through the rear bumper of the vehicle or through any kind of rubber
grommet on the vehicle. If you have to drill a hole, make sure to seal the hole once you route
the wiring through to prevent leaking or moisture damage.
4. Once the wire harness is routed, secure the camera down with the 3M double sided tape.
Make sure that the mounting surface is completely clean before applying the 3M tape. It may
help to use an alcohol pad to clean the surface first.
NOTE
: Make sure to use a properly sized drill bit to drill the hole for the insert. This will help you
to avoid any mistakes in drilling the hole too big or too small.
License Plate
Camera Lens
Mounting
Surface
Cable
Mounting Bracket
Double Side Tape
REVERSE (MIRROR) IMAGING:
The SV-6826.II Camera has built-in circuitry to “mirror” the image so objects on the right of vehicle
appear on the right and objects on the left appear on the left when looking at a standard monitor. If
your existing monitor or in-dash monitor has a reverse camera input where the monitor itself performs
the mirror image, then your picture will not be correct. If this happens, the SV-6826.II camera has
wire that can be cut reverse the image back to normal. (See Wiring Diagram)
