WIRING:
1. Carefully choose a hidden out-of-sight location for drilling the cable hole. Some vehicles may
have an existing hidden rubber grommet or plug available to avoid having to drill into the body.
Be sure to double-check for any wiring or obstructions behind the surface where you are going to
drill the cable hole. Use the rubber grommet to make a watertight seal for the cable where it
passes into the vehicle.
2. Choose a convenient place to run the camera cable up the left, right or center of the vehicle. As
a rule of thumb, try to avoid main factory harness looms that may contain high levels or RF noise
or interference.
3. You can connect the camera power at the rear of the vehicle behind the reverse lights. You may
also connect power inside the vehicle under the dash or in the trunk. The Red power wire goes to
Reverse Light +12V, and the Black wire to Ground. The White wire that comes out of the side of
the harness is for reverse imaging. Keep the wire connected for normal image or cut the wire in
half for reverse image.
4. Run the Yellow RCA video cable to the monitor’s video input or reverse camera input.
MONITOR
WHITE WIRE
Mirror Image Option
Connect to +12V
Reverse Light
RED
WIRE
BLACK
WIRE
Ground
SV-6826.II
CAMERA
YELLOW RCA
Connect to
Monitor
YELLOW RCA
BLUE WIRE
Parking Line Option
SPECIFICATIONS:
1/4 Inch Color CMOS Sensor
Video Output:
1.0 V P-P composite (75 Ohm load)
Dimension (In.):
¾
(L) × 1
¼
(W) ×
1¼ (D)
Supply Voltage:
+12VDC
Weight:
5 Oz.
Power Consumption:
70mA
Pixels:
712 (H) x 486 (V)
Electronic Shutter:
1/50 s – 1/100000s
Resolution:
> 250,000 pixels
White Balance:
Automatic
420 TV lines
Gamma Correction:
0.45
Minimum Illumination:
0.5 LUX / F 1.2
S/N Ratio:
More than 48dB
Lens Type:
Wide Angle
Operating Temp:
-13° to 185° F (-25° to 85° C)
Horizontal Angle:
170°
Gain Control:
Automatic
Vertical Angle:
90°
