ii
Welcome
Thank you for purchasing our Network camera.
This Quick Start Guide is designed to get your system up and running as easily as possible.
This document applies to both the ST-IP-MD36-1 and ST-IP-MD36-2 camera models (1mp & 2mp).
Please read the following safeguard and warnings carefully before you use this camera.
Please keep this document for future reference.
Important Safeguards and Warnings
1
．
Electrical safety
All installation and operation should conform to your local electrical safety codes.
The power shall conform to the requirement in the SELV (Safety Extra Low Voltage) and the
Limited power source is rated 12V DC, DC5V or AC24V in the IEC60950-1. (Power supply
requirement is subject to the camera label).
Please prevent the line cord from being crushed or damaged, especially at the plug, power socket and
the junction from the camera.
Note: Do not connect a PoE power source AND a power supply to the camera at the same time;
it may result in camera damage.
We assume no liability or responsibility for fires or electrical shock caused by improper handling or
installation.
We are not liable for any problems caused by unauthorized modification or attempted repair.
2
．
Environment
Don’t aim the camera at strong light (such as lighting, sunlight and so on) to focus; otherwise it
may cause overexposure, which will affect the longevity of the CCD or CMOS imager.
Please transport, use and store the camera within the range of allowed humidity and temperature. Don’t
keep the camera in a place which is wet, dusty, extremely hot, and extremely cold and with strong
electromagnetic radiation or unstable lighting.
Please do not allow water and other liquids to enter the camera, to prevent the internal
components from being damaged.
Please allow adequate ventilation around the camera to prevent heat accumulation.
Please pack the camera with the standard factory packaging or material with the same quality
when transporting the camera.
Avoid bumps and humidity during transportation, storage and installation.
