6
Figure 2-2
Note:
If the camera needs to be restored to factory settings, long press the “Reset” button shown in
Figure 2-2 for 10 seconds while the camera is powered on
If the camera needs to use the WPS function, short press the “Reset” button shown in Figure 2-
2 for 1~2 seconds when the camera is powered on, then press the WPS button of the router,
generally the camera can be connected to the corresponding router within 1 minute (only
supported by some models).
Step 6
Reconnect the camera dome cover to the camera properly, taking care to align the screws with
the corresponding holes, and fasten the three hex screws with the included hex wrench. The
camera installation is now complete.
2.2 Micro SD Card Installation
Note:
This model of camera does not support Micro SD card functions.
Shut down the power and turn off the camera before you install the Micro SD card.
Step 1 Find the Micro SD Card slot in figure 2-3, open the Micro SD Card slot according to the
direction shown in figure 2-4.
Step 2 Orient the Micro SD Card to the proper direction and install it in the Micro SD card slot.
Step 3 According to the direction shown in figure 2-4, close the Micro SD card slot and keep it locked.
