3
User Code
5. To Reset the Lock back to Factory Default
a) Disconnect the battery
b) Disconnect the cable from the lock
c) Using a poke tool (paper clip or other) depress the Reset button 3 times. This discharges
any latent energy stored in the capacitors inside the lock.
Note: The Reset button is located on the back of the lock, under the round QC
sticker. You will see the word Reset above the Reset access hole.
d) Now press and hold the Reset button. While holding down the Reset button, reconnect
the cable to the lock. Still continuing to hold down the reset button, reconnect the 9V
battery.
e) The lock will continue to beep until the Reset button is released.
Note: If the EntryPad does not beep, repeat steps a) through e) again.
f) The codes in the lock have been restored to factory default as follows:
a. The Manager Code is 1-1-1-1-1-1
b. The User Code is 1-2-3-4-5-6
SECURAM Systems Inc. U.S.A.
