2
been programmed correctly.
The system will revert to standby status if there is no key press within 10 seconds.
Standby status is indicated by two short beeps.
1. To Add the User Code
Note: By default the system will have a User Code installed with a default code of 1-2-3-4-5-
6. If this code has been deleted, follow these steps to add the User Code:
a) Enter the Manager Code and hold down the last digit of this code. Two beeps will sound
indicating a valid code entry. Continue to hold down this digit until two additional beeps
sound. This indicates that the system is now in program mode.
b) Press button “1”. Two beeps will sound, indicating that the system is ready to receive the
new User Code
c) Enter a six digit code. One beep will sound.
d) Repeat the six digit code. One beep will sound, indicating that the six digit codes entered
were the same and the addition of the User Code was successful.
If 3 beeps sound, the programming attempt was unsuccessful. Repeat steps a)
through d).
Note:
Verify the new code at least 3 times before closing the door to make sure the code has
been programmed correctly.
The system will revert to standby status if there is no key press within 10 seconds.
Standby status is indicated by two short beeps.
2. To Disable the User Code
a) Enter the Manager Code and hold down the last digit of this code. Two beeps will sound
indicating a valid code entry. Continue to hold down this digit until two additional beeps
sound. This indicates that the system is now in program mode.
b) Press button “2”. Two beeps will sound, indicating that the system has disabled the User
Code
3. To Enable the User Code
a) Enter the Manager Code and hold down the last digit of this code. Two beeps will sound
indicating a valid code entry. Continue to hold down this digit until two additional beeps
sound. This indicates that the system is now in program mode.
b) Press button “1”. Two beeps will sound, indicating that the system has enabled the User
Code
4. To Delete the User Code
a) Enter the Manager Code and hold down the last digit of this code. Two beeps will sound
indicating a valid code entry. Continue to hold down this digit until two additional beeps
sound. This indicates that the system is now in program mode.
b) Press button “3”. Two beeps will sound, indicating that the system has deleted the existing
