ENFORCER Stand-Alone / Wiegand Proximity Reader
SECO-LARM U.S.A., Inc.
11
Programming Notification Sounds and LED:
Programming the Output Mode and Time (Continued):
Programming the External Alarm Output:
The reader sounds/notifications and LED may be disabled. Setting the reader notification sounds affects all
sounds from the reader, including successful card entry notifications, duress alarm, and wrong-card alarm.
When programming, use the following general formula from within base programming mode (see "Enter and
Exit Base Programming Mode," pg. 6):
– Program Notification Sounds/LED function code (LED will change to steady orange)
– Enable/Disable Notification Sounds/LED
Enable/Disable Reader Sounds/Notifications:
– Disable notification sounds
– Enable notification sounds (default)
– Disable LED
– Enable LED (default)
NOTES:
Disabling the notification sounds affects only the internal sounds and not the external alarm output.
The duress alarm and wrong-card alarm will trigger both the internal notification beep and the external
alarm, depending on their settings.
The key returns you to base programming mode (the LED will flash red). Exit programming mode by
pressing the key (see "Enter and Exit Base Programming Mode," pg. 6).
Output Mode and Output Time:
– Start/stop (toggle) mode. In this case, the output starts when a user card is presented, and stops
when a user card is entered again.
to
– The output triggered by a user card lasts up to 99 seconds before automatically turning
off (1=500ms, default: 5 seconds).
NOTES:
For programming the output timing, 1=500ms. 2~99 represents full seconds.
The key returns you to base programming mode (the LED will flash red). Exit programming mode by
pressing the key (see "Enter and Exit Base Programming Mode," pg. 6).
Examples:
1.
Set the output to toggle mode:
2.
Set the output to 60 seconds:
The external alarm sounds an external alarm when the tamper, duress, or wrong-card alarm (if enabled, see
"Programming the Wrong-Card Lockout/Alarm," pg. 12~13) is triggered. However, when in Wiegand reader
mode (see "Setting the Reader Operation Mode," pg. 7), these settings will have no effect as external alarm
settings are programmed in the controller. Duress and wrong-card alarm output will be passed to the Wiegand
controller, but there is no tamper alarm in Wiegand reader mode.
To program, use the following formula in base programming mode (see "Enter and Exit Base Programming
Mode," pg. 6):
