SECO-LARM Electric Door Strike with Vertical Adjustment
4
SECO-LARM U.S.A., Inc.
Note:
The mounting tabs are only used for
aluminum and metal door frames. This is
commonly done when retrofitting door frames.
To mount the strike where the hollow door frame
material is unsuitable for mounting, do the following:
1.
Punch or drill holes according to the template
for installation of the mounting tabs, and the
anchor nuts that reinforce them.
2.
When installing, do not over-tighten the screws
as small adjustments may be required to
secure a snug fit for the door strike.
Mounting the Trim Plate:
Mounting the Strike Using Mounting Tabs:
Mounting Tabs
Using the stick-on template as a guide:
1.
Drill holes for mounting the strike, and cut a
hole for the face-plate size being used. It is
recommended to cut the hole slightly
smaller than necessary.
2.
Use a file to finish the shaping of the frame.
This will improve the fit and finish of the
installation.
Preparing the Door Frame:
Note:
Trim plate is optional and may not be
required in all installations. Only use the trim
plate to cover any gaps in the door frame.
1.
If the hole cut for the faceplate is too large
or is jagged, the trim plate can be mounted
over the hole to improve the appearance of
the installation.
2.
Screw the trim plate into the mounting holes
at the top and bottom of the door strike
using the included trim plate screws before
installing the strike to the door frame.
Machine
Screws
