Operation of the heat press
Performing transfers
● Turn on the heat press via the main switch.
● Define the desired temperature as well as time parameters and confirm them. The press
then starts to heat up.
● Please refer to previous chapters to learn how to change the settings on the controller.
● Once the press has heated up, you can proceed with the first transfer. The clock starts
counting as soon as the press is closed with the press lever.
● 3 seconds before the set time elapses, a warning signal is sounded (if activated in the
settings), then the press opens automatically.
● You can end the pressing process before the set time has elapsed by pressing the
-
key.
● You can adjust the contact pressure by turning the small hand screw at the bottom of the
press to increase or decrease the distance the lever travels. Turning the knob clockwise
increases the pressure, while turning it counterclockwise decreases it.
● Using the clamping lever at the left of the base element, fix the transfer object as firm and
flat as possible to avoid wrinkling during transfer.
● No settings can be changed during the press operation.
● With each completed press operation, the value indicated by the counter increases by one,
as soon as the specified time has fully elapsed.
Note: Please keep in mind that it takes some time for the press to cool off after it is
switched off. There is a danger of suffering burns until complete cooling.
Secabo GmbH Hochstatt 6-8 85283 Wolnzach Germany [email protected] www.secabo.com
14
