counter (at the right bottom) counts the number of transfers that have already been made during the
current session. The counter can be reset at any time.
Operation
● Connect the heat press to a 230 V power socket using the connection cable supplied.
● Switch on the press with the red rocker switch.
● After a short self-test lines appear in the display.
● Press the OK button.
● Use “UP” or “DOWN” to set °C or °F and press OK.
● Use “UP” or “DOWN” to set the desired temperature and press OK.
● Use “UP” or “DOWN” to set the desired time and press OK.
● You can now make the first transfers. The timer starts running as soon as the press is
closed with the press lever.
● 3 seconds before the end a warning signal sounds. After the set time has expired, the press
opens automatically.
● The contact pressure can be adjusted with a wheel on the surface of the press. Clockwise
rotation causes less pressure - counter clockwise rotation causes more pressure.
● The settings cannot be changed during pressing.
● Each time the pressing process is completed, the counter display increments by one after
the set time has expired.
● You can reset the counter by pressing RESET for longer than 5 seconds.
Note: Please note that a certain time is required before the press cools down after it is
switched off.
Maintenance and cleaning
Maintenance work should always be accomplished with the press switched off and cooled down.
The plug must first be disconnected from the power socket. Consult Technical Support before
carrying out any maintenance work.
Clean the press regularly with a soft cloth and mild household cleaner to remove adhesive residues
etc. Never use scouring sponges, solvents or gasoline!
Recommended times and temperatures
These values are only guidelines;; they can vary from material to material and should always be
checked before pressing.
Secabo GmbH Hochstatt 6-8 85283 Wolnzach Germany [email protected] www.secabo.com