These settings are queried in sequence:
● Baud rate - configurable to 38400, 57600, or 115200, depending on the value configured for
the interface on the computer - only when connecting via serial port.
● XP and YP - in the second and third menu point, you can calibrate the vinyl cutter correctly.
Correction may be required here due to wear to the mechanical parts. The X and Y scaling
of the data can be changed by changing the XP and YP values. If, for example, an object
for which a length of 100 cm was entered on the computer is cut on the vinyl cutter to a
length of only 98cm, it is necessary to correct the corresponding scaling value on the
plotter. Otherwise, these values should not be changed.
● Reset settings - here you can restore the vinyl cutter's factory settings. To do so, the right
arrow key must be held for 3 seconds.
● Firmware - here you can view the firmware version installed on the cutter.
Contour cut with LAPOS
LAPOS is a system for the positioning of printed media in your C V / S II vinyl cutter, allowing you
to cut printed elements with absolute contour accuracy, and without misalignment or distortion. The
use of LAPOS is explained in the following steps.
Calibration:
Before the first use of LAPOS, the cutter requires an initial calibration to determine the correct laser
offset. DrawCut provides two procedures to achieve this, one fast and one detailed option.
● The first step is to open the "Vinyl Spooler".
Secabo GmbH Hochstatt 6-8 85283 Wolnzach Germany [email protected]
14
