Sebury B6 Plus, Руководство пользователя

Страница: 13 / 35

B6K2 Standalone Access Controller User Manual V1.0
NetDigital Security
http://www.netdigital.com.au
13
2.3 Debugging
After power on, conduct the test according to Getting Started till you can open door by reading card, input PIN or exit button.
3 Getting Started
Writing Conventions:
➢ Keypad operation only can be used between “0123456789*#” these12 buttons
➢ “…” means continue similar operation as indicated from previous operations.
➢ “,”is not an actual operation, it’s just punctuation.
➢ “()” means the serials of digital numbers which will be type into the controller, like PIN code, ID number ,card number
etc.
Operation Conventions:
➢ “Beep-”one long beep means the operation was correct. “beep-beep-beep” three short beeps mean operation was
incorrect. LED light turn to green means operation was successful.
➢ “#” means previous operation was received by system, it normally uses at the end of the digital numbers of PIN code, ID
number, card number or parameter, when you type this key it means input is finished.
➢ “ * ” means cancel current operation or back to previous menu
➢ Management menu fix to 2 digits, from 00~99, Don't press “#” on the menu behind, after into menu, LED light turn to
orange(or purple),if operation failed will hear“beep-beep-beep”3 short beeps.
➢ Under the management menu operation mode, if system detected without any operation over 30 seconds, it will back to
standby mode automatically.
Indicator light and buzzer prompt:
Operation Status Indicator light Buzzer
Standby mode Red
Successful operation Green A long beep
Operation incorrect 3 short beeps
When admin card enter
2 short beeps
When admin card exit
A long beep
Press digit key A short beep
Press * key A long beep
Inputting opening door PIN Red slow flash
Both read card and input PIN Mode, after read
the card
Red slow flash
Multi-card reading open the door, when the
card reading is not over yet
Red slow flash
Enter the first zone admin main menu Red slow flash
Enter the second zone admin main menu Blue slow flash
Enter the first zone setting status Orange
Enter the second zone setting status Purple