7
6. Startup
6.1 Activation of the CO alarm detector
The CO alarm detector is activated during the installation, for example on the wall, by means of a
screw (
see chapter 5
). When activated, a beep sounds and all three LEDs light up briefly.
1.
Drill a Ø 5.0mm hole in the wall and insert the dowel into the drilled hole.
2.
Turn in the screw until the screw head protrudes about ca. 55mm from the wall.
3.
The mounting hole for the screw is located on the rear of the housing. Insert the screw head
into the mounting hole and press the CO alarm detector slightly down. If the CO alarm
detector is properly attached, a short beep sounds while the LEDs briefly flash.
4.
Test the alarm with the button TEST/SILENCE.
Make sure that the unit „alarm“(4x short
beep) sounds.
Note:
If the CO alarm detector is not installed properly, the function of the device is not
guaranteed!
