2
Thank you for choosing a product of SEBSON. Please read the instructions carefully and keep them
for looking up before start-up this product. A long and failure-free operation can only be guaranteed if
the installation and start-up is done properly.
Note:
Please read all warnings and instructions before using this equipment! Keep these operating
instructions for future reference!
This CO-alarm detector is used for early warning in case of hazardous concentration of carbon
monoxide in rooms. As soon as a noxious concentration of carbon monoxide is detected, the red LED
flashes and a loud alarm sounds.
This CO alarm detector may only be used in private rooms.
The CO-alarm detector must be activated before use (
see chapter:6.1
).
After a maximum of 10 years as well as with signaling the battery fault signal, the CO alarm
detector must be replaced.
CO-alarm detector is particularly suitable for rooms in which fuel burners (e.g. gas heaters or
gas boilers) are installed.
Please note that this CO alarm detector is not a substitute for smoke-alarm-, gas- or heat-
detector!
The installation of the CO-alarm detector is not a substitute for the proper installation, use and
maintenance of fuel burners, including appropriate ventilation and exhaust system!
Scope of delivery:
CO-alarm detector type: GS810
1 screw and 1 dowel for fixing and activation
Model-number:
GS810
CO alarm detector GS810
