Assembly & Operation Manual
Make sure no slop and binding in system
Run servo wires together in harness.
NOTE : Make sure no wires can touch tailpipe. Touching tailpipe will melt wires and
create short circuit. This will lead to crash.
FIN & RUDDER
NOTE:
Make sure to have some sort of protective foam on the work bench. This will
protect the paint surface from unwanted dents. Mark √ each step.
Make pushrod. Double ball link.
Fit horn to servo and set travel on TX.
Mark location of servo horn on fin skin. Cut slot for horn in skin.
Fit servo to mount.
Fit the pushrod to horn. Mark location of rudder horn.
Note travel of rudder to clear horn. Cut slot for 2 horns and epoxy.
Fit pushrod.
Secure extension lead.
Run wire clear of pipe.
When happy bolt fin to rear fuselage with 2 set
screws.
Check operation of rudder.
P-16
Photo 25
Photo 26
Photo 27
Photo 28