F
OR
THE
U
SER
- I
MPORTANT
-
The device should not be used by children or by individuals
with reduced physical or psychological abilities unless super
vision is provided or instruction given on how to operate it.
Do not let children play with the device; keep radio controls
out of their reach.
CAUTION: Keep this instruction manual in a safe place and
observe the important safety instructions contained within it.
Nonobservance of these instructions may lead to property
damage and serious accidents.
Examine the system frequently to check for any signs of
damage. Do not use the device if it needs to be repaired.
We recommend carrying out the opening and closing oper
ations of the blind or rolling window shutter in visible condi
tions, ensuring no persons are in a dangerous condition dur
ing movement.
Warning
All procedures which require the casing to be opened (such as
wire connection, programming, etc.) must be carried out during
installation, by skilled staff only. For any other procedure which
requires the casing to be opened again (reprogramming, re
pairs or site modifications), please contact the technical assist
ance service.
SEAV s.r.l.
hereby declares that the below products:
LG2215 – LRS2215 – LRS2215 SET –
LRH2215
conform to the specifications in the Directives R&TTE
99/5/EC, EMC 2004/108/EC, LVD 2006/95/EC.
5
Rev. 1.1 03/12/10
F
OR
THE
I
NSTALLER
- I
MPORTANT
The control unit was designed to enable the installer to auto
mate shutter movement while adhering to the provisions set
out by current legislation. Compliance with these obligations
and the implementation of the minimum safety requirements is
the responsibility of the installer.
We recommend installation is performed in full compliance with
EN 60335297 (“Household electrical appliances and similar
Safety”, part 2 “Particular requirements for drives for rolling
shutters, awnings, blinds and similar equipment).
In this regard, realise the plant combined with this components
control unit (motor, mechanical parts, etc.) resulting conform in
satisfying the necessary safety requisites.
The control unit must be permanently connected to the
power supply network and is not equipped with any type
of 230 V a/c electric line sectioning device. The installer
is responsible for installing a sectioning device in the
system.
An omnipolar switch with overheating category III
must be installed. It must be positioned in such a way that it is
protected against accidental closures.
For connections (power supply and motor output) we recom
mend the use of flexible wires with an insulating sheath in har
monised polychloroprene (H05RNF). The wires should have a
minimum crosssection of 0.75 mm
2
.
Fasten the connection cables using the cable clamp sup
plied with the product kit.
In choosing the motor to combine with the control unit, keep
to the maximum power indications contained in this manual.
For the radio receiver to operate correctly when two or
more control units are used, we recommend that you install
the devices at least 3 metres away from each other.
If two or more control units are installed, we recommend
only one Wireless Sensor is used in order to avoid radio in
terference.
