for 5 seconds; the T. MOT. and WIND SPEED LEDs will flash
alternately and the user has 30 seconds within which to select
the functions of extended menu 2 using the SEL and SET but-
tons. When this time has elapsed the control unit returns to the
main menu.
---------------------- EXTENDED MENU 2 -----------------
Reference LED LED Off LED On
A) CODE Auto movements = OFF Auto movements = ON
B) SENS. CODE Anemometer Test = OFF Anemometer Test =
ON
C) T. MOT. Flashing beacon ON/OFF
D) WIND SPEED Flashing beacon ON/OFF
A) CODE (Automatic Movement Lock):
The control unit enables the prevention of automatic move-
ments (Up / Down sun blind movements on the Wind sensor
command or Automatic sensors function), so that if a Stop com-
mand is sent from a radio control during movement, the control
unit momentarily locks the automatic movements until a new
Up or Down command is sent.. The control unit is supplied by
the manufacturer with the Automatic Movement Lock disabled;
to enable the function proceed as follows: check that the exten-
ded menu is enabled (T. MOT. and WIND SPEED LEDs start
flashing simultaneously), use the SEL button to navigate to the
CODE LED when flashing and press the SET button: the
CODE LED remains lit in a constant manner and programming
is complete. Repeat the procedure to restore the previous con-
figuration.
B) SENS. CODE (Wired Anemometer Test):
The control unit can be used to check the operation of the con-
nected Wind sensor, and to make sure the rotation direction is
correct. When installing the device, we recommend the blind is
placed in an intermediate position so that you can see all con-
firmation movements during the test procedures. After making
sure the Wind sensor is operating correctly, you must remem-
ber to disable the Test.
Anemometer Test:
manually rotate the Anemometer blades; at
the same time, the control unit will cause an upward movement
lasting 5 seconds.
Programming:
The control unit is supplied by the manufacturer
with the Wired Wind sensor test disabled. To enable the Test,
proceed as follows: check that extended menu 2 is enabled (T.
MOT. and WIND SPEED LEDs start flashing simultaneously),
use the SEL button to navigate to the SENS. CODE LED when
flashing and press the SET button: the SENS. CODE LED re-
mains lit in a constant manner and programming is complete.
Repeat the procedure to restore the previous configuration.
Important:
for information on the Wireless Wind sensor test,
please refer to the Wireless Wind sensor manual.
R
ESET
To reset the default configuration of the control unit, press the
SEL and SET buttons simultaneously; all indicator
LEDs will
switch on and then off again immediately.
4
Rev. 1.1 03/12/10
