Seat Toledo 2019, Руководство пользователя, Страница: 49 / 300

The essentials
with a stone or similar to prevent the vehi-
cle from moving.
Repairing a tyre with the anti-punc-
ture kit
Fig. 58
Standard display: contents of the anti-
puncture kit.
The anti-puncture kit is located under the
floor panel in the luggage compartment.
Sealing the tyre
●
Unscrew the tyre valve cap and insert. Use
the
›››
Fig. 58
1
tool to remove the insert.
Place it on a clean surface.
●
Shake the tyre sealant bottle vigorously
›››
Fig. 58
10
.
● Screw the inflator tube
›››
Fig. 58
3
into
the sealant bottle. The bottle's seal will break
automatically.
●
Remove the lid from the filling tube
›››
Fig. 58
3
and screw the open end of the
tube into the tyre valve.
●
With the tyre sealant bottle upside down, fill
the tyre with the contents of the sealant bot-
tle.
●
Remove the bottle from the valve.
●
Place the insert back into the tyre valve us-
ing the tool
›››
Fig. 58
1
.
Inflating the tyre
●
Screw the compressor tyre inflator tube
›››
Fig. 58
5
into the tyre valve.
●
Check that the air bleed screw is closed
›››
Fig. 58
7
.
● Start the engine and leave it running.
●
Insert the connector
›››
Fig. 58
9
into the
vehicle's 12-volt socket
›››

page 138 .
●
Turn the air compressor on with the
ON/OFF switch
›››
Fig. 58
8
.
●
Keep the air compressor running until it rea-
ches 2.0 to 2.5 bar (29-36 psi/200-250 kPa).
A maximum of 8 minutes .
●
Disconnect the air compressor.
●
If it does not reach the pressure indicated,
unscrew the tyre inflator tube from the valve.
● Move the vehicle 10m so that the sealant is
distributed throughout the tyre.
●
Screw the compressor tyre inflator into the
valve.
●
Repeat the inflation process.
●
If the indicated pressure still cannot be
reached, the tyre is too badly damaged. Stop
and request assistance from an authorised
technician.
●
Disconnect the air compressor. Unscrew
the tyre inflator tube from the tyre valve.
●
When the tyre pressure is between 2.5 and
2.0 bars, continue driving without exceeding
80 km/h (50 mph).
● Attach the sticker
›››
Fig. 58
2
to the in-
strument cluster, within the driver's visual
field.
●
Check the pressure again after 10 minutes
›››
 page 81 .
 ›››
in TMS Anti-puncture kit (Tyre
Mobility System)* on page 80

›››
page 79
47