Seat Toledo 2019, Руководство пользователя, Страница: 101 / 300

Instruments and warning lamps
●
Do not operate the instrument panel con-
trols when driving.
CAUTION
●
To prevent damage to the engine, the rev
counter needle should only remain in the
red zone for a short period of time.
●
When the engine is cold, avoid high revs
and heavy acceleration and do not make
the engine work hard.
For the sake of the environment
Changing up a gear in time reduces fuel
consumption and noise.
Revolution counter
The rev counter indicates the number of en-
gine revolutions per minute
›››
Fig. 111
1
.
Together with the gear-change indicator, the
rev counter offers you the possibility of using
the engine of your vehicle at a suitable
speed.
The start of the red zone on the dial indicates
the maximum engine speed which may be
used briefly when the engine is warm and af-
ter it has been run in properly. Before reach-
ing this range, you should change to a higher
gear for vehicles with a manual gearbox or
for automatic gearboxes put the selector lev-
er in “D” or take your foot off the accelerator
pedal.
We recommend that you avoid high revs and
that you follow the recommendations on the
gear-change indicator. Consult the addition-
al information in
›››
page 208 .
CAUTION
Never allow the rev counter needle
1
›››
Fig. 111 to go into the red zone on the
scale for more than a very brief period, oth-
erwise there is a risk of engine damage.
For the sake of the environment
Changing up a gear early will help you to
save fuel and minimise emissions and en-
gine noise.
Indications on the display
A variety of information can be viewed on the
instrument panel display
›››
Fig. 111
3
de-
pending on the vehicle equipment:
●
Bonnet, rear lid and doors open
›››

page 31 .
●
Information and warning texts.
● Mileage.
●
Time.
●
Navigation instructions.
● Outside temperature.
●
Compass.
●
Shift lever position
›››
page 205 .
●
Recommended gear (manual gearbox)
›››
page 208 .
●
Multifunction display (MFD) and menus with
different setting options
›››

page 27 .
●
Service interval display
›››
 page 33 .
●
Second speed display
›››
page 100 .
●
Speed warning function
››› 
page 32 .
●
Start-Stop system status display
›››
page 215 .
●
Low consumption driving status

›››
page 100
● Identifying letters on engine (LDM)
›››
page 100 .
Distance travelled
The odometer registers the total distance
travelled by the car.
The odometer (
trip
) shows the distance
travelled since the last odometer reset. The
last digit of the trip recorder indicates distan-
ces of 100 metres or one tenths of a mile.
●
Briefly press the button
›››
Fig. 111
4
to re-
set the trip recorder to 0.
●
Keep the button
4
pressed for about 3
seconds and the previous value will be dis-
played.
»
99