Seat Toledo 2019, Руководство пользователя, Страница: 102 / 300

Operation
Time
●
To set the time, keep the button
›››
Fig. 111
4
pressed for more than 3 seconds to select
the hour or minute display.
● To continue setting the time, press the up-
per or lower part of the button
4
. Hold but-
ton down to scroll through the numbers
quickly.
●
Press the button
4
again in order to finish
setting the time.
The time can also be set on the Easy Con-
nect system using the

button and the
function button
SETTINGS > Date and
time
›››
 page 24 .
Compass
With the ignition on and the navigation sys-
tem on, the cardinal point corresponding to
the direction of travel of the vehicle is dis-
played on the instrument panel.
Selector lever position
The selected gear is displayed on the side of
the selector lever and on the instrument pan-
el display. In positions
D and S , and with the
Tiptronic, the corresponding gear is also dis-
played.
Outside temperature display
If the outside temperature is lower than ap-
proxi4°C (+39°F), the “ice crystal
symbol”

on the outside temperature dis-
play also lights up. This symbol remains lit un-
til the outside temperature e6°C
(+43°F)
›››
.
When the vehicle is stationary, when the aux-
iliary heater is switched on or when driving at
very low speeds, the outside temperature in-
dicated may be higher than the actual tem-
perature due to the heat produced by the en-
gine.
The margin of measurement ranges from
-45°C (-49°F) to +76°C (+169°F).
Recommended gear (manual gearbox)
The recommended gear in order to save fuel
is displayed on the instrument panel while
you are driving
›››
page 208 .
Second speed display (mph or km/h)
In addition to the speedometer, the speed
can also be displayed in a different unit of
measurement (in miles or in km per hour).
This option cannot be deactivated in models
destined for countries in which the second
speed must always be visible.
The second speed display can be adjusted in
the Easy Connect system by means of the

button and the function button
SETTINGS
> Units
›››
 page 24 .
Speed warning
When the speed setting is exceeded, this will
be indicated on the instrument panel display.
This is very useful, for example when using
winter tyres that are not designed for driving
at the maximum speed of the vehicle
›››
 page 32 .
The speed warning settings can be adjusted
in the Easy Connect system by means of the

button and the function button
SETTINGS
> Driver Assistance
›››

page 24 .
Start-Stop operating display
Updated information relating to the status is
displayed on the instrument panel
›››
page 215 .
Low consumption driving status

*
Depending on the equipment, when driving,
the

display appears on the instrument
panel when the vehicle is in low consumption
status.
Identifying letters on engine (LDM)
Hold the button
›››
Fig. 111
4
down for more
than 15 seconds to display the identifying let-
ters of the vehicle engine (LDM). To do this,
the ignition must be switched on and the en-
gine switched off.
100