Seat Toledo 2019, Руководство пользователя, Страница: 81 / 300

Self-help
WARNING
●
If you have a puncture in moving traffic,
switch on the hazard warning lights and
place the warning triangle at the obliga-
tory distance. Observe applicable local le-
gal regulations. This is for your own safety
and that of other drivers.
● If you have a flat tyre, stop the vehicle as
far away as possible from moving traffic.
Stop on flat, solid ground.
●
If you have to change the tyre on a gradi-
ent, block the wheel opposite the wheel
being changed by placing a stone or simi-
lar object under it to prevent the vehicle
from rolling away unexpectedly.
●
If the vehicle has been fitted with tyres or
alloys that are different to those fitted in
manufacture, the instructions
›››
page 258,
New tyres or wheels must be followed.
● Always raise the vehicle with the doors
closed.
●
Never place parts of your body, e.g. arms
and legs, underneath the vehicle when it is
supported only by the jack.
●
Secure the base of the jack with suitable
supports so that it cannot slip. The jack
could slide if the ground below it is soft and
slippery and the vehicle could slip off it.
Therefore, place the jack on a firm surface
or use a large, stable base. On a slippery
surface, e.g. tile, use a non-slip base such
as a rubber mat.
●
Never start the engine when the vehicle is
jacked. Risk of injury.
● The jack should only be used in the cor-
rect jacking points.
CAUTION
●
The prescribed tightening torque for
wheel bolts on steel and alloy wheels is
120 Nm.
●
If the anti-theft wheel bolt is overly tight-
ened, this could damage the bolt and the
adapter.
Note
● The set of anti-theft wheel bolts or the
adapter are available from authorised
SEAT dealers.
●
Please observe the relevant local legal
regulations when changing the wheel.
Wheel bolts
The wheel bolts are matched to the rims.
When installing different wheels, e.g. to fit
light alloy wheels or wheels with winter tyres,
it is important to use the correct wheel bolts
with the right length and correctly shaped
bolt heads. This is essential for a secure fit of
the wheels and for proper operation of the
brake system.
Note
●
Never grease or oil the wheel bolts!
●
If the wheel bolt is very tight, it may be
possible to loosen it by pushing down the
end of the box spanner carefully with your
foot. Hold on to the vehicle for support and
take care not to slip.
●
If you notice that the wheel bolts are rus-
ty and difficult to turn when changing a
wheel, they must be replaced before hav-
ing the tightening torque checked.
Tyre repairs
TMS Anti-puncture kit (Tyre Mobili-
ty System)*
Read the additional information carefully
›››
 page 47
The Tyre Mobility System is stored in a box
under the carpet in the boot.
Using the Tyre Mobility System you can relia-
bly seal tyres damaged by foreign bodies,
provided that cuts or punctures are no larger
than approx. 4 mm in diameter. Do not re-
move the foreign bodies, e.g. bolts or nails,
from the tyre!
The tyre must be repaired immediately.
»
79