SeaSucker SX6150, Быстрый старт

Страница: 4 / 9

Next, slide one of the front bar mounts onto one of the cross bars. Slide the other front bar mount onto the other
side of the same bar; make sure the vacuum pumps
on the mounts are pointing in the same direction.
Remove the protective covers from the mounts and
place the bar and mounts onto the roof of your
vehicle just behind the front windshield; the vacuum
pumps should be pointing towards the rear of the
vehicle. Position each of the front bar mounts as
near to the front corners of the roof as you can (see
“Where to Attach” below). Attach the vacuum
mounts (see “Attaching Your Rack” below) and
center the cross bar between the front bar mounts.
If you purchased the folding bars, rotate the bar so
that the center oval opening is facing downwards
towards the roof of the vehicle. Using the 5/16” hex
wrench, tighten the clamp bolt on each front bar
mount. Your front cross bar should now be custom-
fit to your vehicle; you can use it or remove it from
the car (see “Removing your Rack” below).
Repeat this process for the rear bar mounts and
cross bar, mounting them just in front of the rear
window.
Where to Attach
Monkey Bars are specifically designed to attach to
a car’s roof top. Ideally, the vacuum mounts on your rack should be attached in the front and back corners of
your car’s roof, where the roof is most solid. The metal in the middle of some car roofs may not be sturdy enough
to support the weight of your rack and whatever you may be transporting.
Each vacuum mount on your SeaSucker rack should attach to clean, unobstructed metal or glass surface. The
vacuum pads will not attach over a seam or other surface incongruity.