SeaSucker SX6150, Быстрый старт

Страница: 2 / 9

The SeaSucker Monkey Bars require simple assembly to be ready for use. Ideally, you will assemble your rack
near your vehicle so you can custom fit the rack to your roof.
The cross bar clamps attach to the front and rear bar mounts with a nut and bolt. Drop a clamp into the pivot slot
of one of the mounts; orient the clamp so that the clamp-tightening bolt is facing the same direction as the bolt
hole. Insert a bolt into the bolt hole, through the clamp, and out the nut hole. See the diagram to the left for a
graphic description of the difference between the bolt hole and the nut hole. Thread the nut onto the end of the
nut as tightly as you can by hand and press and hold the nut against the nut hole. Using the 5/32” hex wrench to
turn the bolt and the 7/16” wrench to hold the nut, tighten the bolt until the end of the bolt is just even with the
outside end of the white nylon locking insert on the inside of the nut. If you tighten the clamp beyond that, it might
interfere with the clamps ability to pivot in the slot. Repeat for the other three bar mounts.
Assemble your cross bars next. First remove the protective plastic cap on the end of the threaded connector.
Find the Lube Tube that came with your rack and put a drop or two on your fingertip. Spread the lube onto the
exposed threads to create a thin film of lube. This will prevent the threads from seizing together once assembled
so that you can unscrew the bars for easier storage or transport.
Now line up the threaded connector with the open bar end and thread the two pieces together. Continue until the
threaded connector is fully seated in the bar (it should look like the other side that came preassembled from the
factory). Give the bars a firm twist to complete the assembly -
nothing more than hand pressure should be
needed to make a secure connection. Repeat for the second bar.