STEP 5.
Recheck all connections.
STEP 6
Install Lanyard with the Fork Clip seated on the Plunger.
STEP 7.
Reconnect battery.
STEP 8.
Start engine. If engine does not start: disconnect battery,
recheck all electrical connections, reconnect battery and restart
engine.
STEP 9.
Remove Lanyard. Engine should stop immediately.
Diagram A
I/O and Inboard Wiring
(basic wiring; no specific manufacturer)
ELECTRICAL CONNECTIONS: OUTBOARD USE ONLY
(NORMALLY CLOSED)
Use 16 AWG Black stranded, insulated marine quality wire for all
outboard applications. (Type HDT, THW, UL 1426 or equivalent.)
This interrupt switch is designed for use with outboard motors equipped
with grounding type emergency stop circuits only!
CAUTION
STEP 1.
Disconnect all batteries and any auxiliary on-board or dockside
power supplies.
STEP 2.
Remove Engine Cover.
STEP 5.
Strip one end of each wire and crimp on an insulated 1/4 inch
female disconnect terminal. A crimping tool designed for insulated
terminals MUST be used.
web: www.seastarsolutions.com
SeaStar Solutions 640 North Lewis Road, Limerick, PA 19468 USA
Page 11 of 20
STEP 4.
Measure and cut two lengths of black 16 AWG marine quality
wire of sufficient length to connect one Interrupt Switch terminal to the
Emergency Stop Wire and the other terminal to a System Ground. (See
Diagram B.)
STEP 3.
Locate the correct color emergency stop wire for your motor.
(See Reference Table 1
.
)
