SERVICE
6
Impeller Replacement (Figure 6)
1. Unplug cord from power source.
2. Disconnect discharge piping at the check valve and lift
pump out of sump.
Do not lift pump by power cord, use T-
handle on top of motor, or lift out of sump using
piping.
3. Remove screws from lower volute housing and separate
volute halves.
4. Hold shaft with screwdriver in slot in end of shaft; un-
screw impeller from shaft.
5. Thread new impeller onto shaft. Hold shaft with screw-
driver and tighten impeller firmly hand tight.
6. Remount lower volute housing.
7. Lower pump into sump by piping, then reattach dis-
charge piping to check valve sleeve. Plug in unit.
8. Pump is ready for operation. To avoid flooding, test pump
before operating by filling sump and running pump
through one complete cycle to be sure that switch works.
Switch Replacement (Figure 7)
NOTICE:
Float must be able to swing through its complete
arc without interference from sidewall of sump, plumbing
or any other object.
1. Unplug cord from power source.
2. Remove tether clamp screw and slide cord from clamp.
Unscrew T-handle to remove cord.
3. Insert new cord in tether clamp in same location on cord
with respect to float.
4. Tighten tether clamp screw. Connect T-handle to pump.
5. Check sump pump operation by filling sump with water
and observing operation through one complete cycle.
Failure to check installation with water
in sump can lead to improper operation, premature
pump failure and flooding.
Disassembly
Reassembly
Notice
: Submerge complete pump in a
disinfectant solution ( chlorox or chlorine )
for at least one hour before disassembling
pump.
Screwdriver
slot
Lower
Volute
Housing
Upper
Volute
Housing
Impeller
Volute Screw
( 11 Places )
T-Handle
Turn impeller
counter-clockwise
hand tight.
Figure 6
3-1/2"
Tether clamp
screw
Clamp
Figure 7
